PickIt M2 Photo Printer

Description

1. Android Device
A TYPE * NFC Support Android Device ONLY
1) Turn NFC on in your smart phone.
2) Tap the phone on the top of Pickit printer.
Google Play Store app installation page will show up.
3) Install the app into your smartphone from the store.
B TYPE
1) Go to Google Play Store in your smartphone.
2) Search “Pickit Printer”
3) Install “Pickit Printer” into your smartphone.

Power and Active Status
Battery Status
Status
White Flickering
Pink Flickering
White
Red Flickering
Red Flickering
White
Off
Printing
F/W Upgrade
No Cartridge
Error (Paper Jam, etc)
Waiting / Cooling
Power ON (z)
Power OFF (2Sec)
Status
Charging
Red Flickering
Red Flickering
Red
Charging Complete Green
Low Battery
Battery Empty
Troubleshooting
* In case of multiple
printers are available
App
Launch
Camera Camera
Gallery Gallery
Select
Choose
Photo
Choose
Photo
Select
Print
Select
Printer
Printing
Symptom
Paper Jam
Image quality
is not good.
Printer is
not responding
Power off and Power On again. Paper will be automatically ejected
If not, please contact customer service.
Print quality could be less if your photo source has low resolution.
Press Reset button with sharp tool like pin.
Over 1280 x 2448 pixel is recommended for best image quality.
Cause / Solution
2. Apple Device
1) Go to Appstore in your iPhone, iPod touch or iPad.
2) Search “Pickit Printer”
3) Install “Pickit Printer” Application into your device.
1. Android Device
A TYPE * NFC Support Android Device ONLY
1) Turn NFC on in your smart phone.
2) Tap the phone on the top of Pickit printer.
Google Play Store app installation page will show up.
3) Install the app into your smartphone from the store.
B TYPE
1) Go to Google Play Store in your smartphone.
2) Search “Pickit Printer”
3) Install “Pickit Printer” into your smartphone.
2. NFC and WiFi Direct * NFC, WiFi Direct support devices ONLY
1) Turn NFC and WiFi on in your smartphone.
* Set the NFC setting as P2P mode.
2) Tap your device on the center of the printer
where the NFC mark is.
3) Within 20 seconds, the app will automatically
connect to WiFi Direct
4) When the printer is connected to WiFi Direct,
green mark will be shown in the app.
1. WiFi Access Point (AP) *Apple and Android Devices.
1) Turn WiFi on in your smartphone.
2) Go to WiFi setting and find “Direct-Cube-XXXX”.
* Printer names are vary and 4 digits. The 4 digits are combination of
number and alphabet.
3) Password is “12345678”.
4) Select the WiFi network to connect the printer.
NOTE
* Photo Paper will go in and out 4 times (YMCO, Yellow, Magenta, Cyan,
Overcoating). Do NOT touch the paper during printing process for best
image quality.
* Do not pull paper out by force during printing.
* Do not place an object in front of the paper exit slot.
* Use the latest Pickit application for best print quality. Check the latest app
version from Google Play Store and Apple Appstore.
* PicKit Printer has Built-in Battery. Charge the printer before using.
* Handle with care during charging to prevent electric shock.
* Do not disassemble or deform.
* Avoid too high or low temperature or humidity.
* If NFC tag is not read, check its position on the printer and smartphone.
Then try again.
* The higher resolution the image has, the higher quality the printed
photo has. Recommended image size is 1280 * 2448 pixel.
* Operating Temperature : 0 ~ 40℃